Have you ever tried to alter a blouse that was lower at the neck than you were comfortable with?
To make this alteration, we are going to do two things: take up the front shoulder seam and take in the collar.
Generally, you don’t need to take up the back of the blouse, but have the customer try it on so you can see how the back fits.
If the back fits well, don’t touch it.
If it doesn’t, you could pull up the back and front at the same time.
This back of this blouse fit great, so it didn’t need to be altered.
The only seam on this collar was at the back:
and I was glad because I didn’t want to mess with the “fluff” on the front.
The center back neck seam was stitched and then gathered to fit:
Let me explain what we’re going to do and then we’ll get after it.
We are going to decrease the circumference of the neck at the middle back seam and when we do that, we’ll need to decrease the circumference of the top as well.
To begin, take a seam ripper and unstitch the stitches that hold the collar and the shoulder seam together:
Take out the stitches from just past one shoulder seam, all around the back of the neck to just past the other shoulder seam like this:
Next, you’ll want to open up the shoulder seam. This was a delicate knit and I had to be careful where I placed my seam ripper so as not to cut the knit, but just cut the stitch:
I opened up the shoulder seam halfway:
Once that was opened up, I was able to shorten the front of the blouse by pinning like this:
Stitch that new shoulder seam by sewing along the original back shoulder seam line and trim off the excess front fabric.
Next, you’ll need to take in the back neck seam on the collar. Can you see the excess collar material?
Since I took one inch off of the front of the blouse on the left and the right for a total of 2″, I need to take up 2 total inches on the collar as well.
I took the seam apart and stitched up two inches of fabric and trimmed the seam. You may not need to take the seam apart. You might just fold the collar at the original seam line and stitch across at the one inch mark (you are taking one inch from the left side and one inch from the right side to equal 2″)
I apologize that the photo is not real clear, but I hope you get the idea:
Now, stitch the collar to the neck edge of the blouse. The collar and the blouse should fit perfectly.
You can see the newly adjusted collar:
You might want to re-serge or zigzag any uneven edges.
That’s all there is to it!
If you have a t-shirt type top, you may need to work with ribbing or a facing.
Use the same principle of taking up the shoulders and taking in the circumference of the top to the measurements you need.
This will work for tank tops too.
Unless you have a really long top, you may not be able to adjust more than a couple of inches before it affects the length of the blouse or top.
But this should help those tops that are just a little too low for your comfort level.