How To Take In The Crotch Seam on Pants

I just got an email from a reader whose husband’s pants are hanging too low in the crotch area and she wanted to know how to take in the crotch seam on pants.

It’s a very common problem.

I thought about how to show you with a pair of slacks, but I think you’ll catch the idea much better and faster with a diagram.

It’s a very easy alteration.

(By the way, if you need more room in the crotch area, be sure to read this post on How To Put in Gussets in Pants or Shirts.)

But back to this alteration…

Please read the entire post before beginning as it has some details you need to know.

First, figure out how much material needs to be taken in.

It would be awkward for you to pin up that area on a customer while they are wearing the pants, so have them do it before they get to your establishment.

Sometimes, I pin up an amount and then have the customer try them on and make adjustments from there if needed.

Once that amount is known, then you are going to open up the crotch seam (this seam is also called the rise. It is the seam that runs from the waist in the front down the center front and up the backside to the back waist seam.) Think of it as the vertical seam where the crotch seam and the inseams intersect.

Open up at least twice the amount you’ll need to take in.

In other words, if you are taking in 2 inches total, then open up about 4 inches of the crotch seam.

Don’t open up the inseam though.

Keep that intact.

The only sewing done will be on the inseam.

Let’s say that you need to take up a total of two inches in the crotch. That means you’ll need to take in one half inch on each inner leg seam as illustrated in the diagram below. You have 2 backs (a right back to the pants and a left back (1/2″ + 1/2″ = 1″ total) and 2 fronts (1/2″ + 1/2″ = 1″ total). If you add the fronts and the backs you get a total of 2″ altogether.

You can see what the new seam will look like based on the dotted line in the diagram below:

(The diagram is only to show you what the pattern pieces would look like if they were sitting on the table). I want to show you the areas where you’ll sew on the front of your pants and the back of your pants. To summarize, you’ll only be opening the crotch seam (or rise) and only sewing the inseam on this alteration. If you think about it as you look at the diagram above, when you take off that excess on the inseam it will automatically shorten the crotch seam (rise) in the pant. It is also important to note that doing this alteration will not affect the length of the pants, as you might wonder about that.)

Now, once that crotch seam is open, put front left leg and the back left leg together and stitch along your own dotted lines being careful to taper the seam back to the original seam line down the leg.

Do the same with the right front leg and the right back leg.

Once you do that, the crotch seam is the exact measurement it needs to be.

This may seem like a strange way to alter the crotch seam, but trust me, this works!

Once you have stitched the new seams, along your own dotted lines, you can trim the seam allowances if you need to.

Otherwise, you may have too much bulk.

Now, stitch up the original crotch seam along the original seam line.

That’s all there is to it!

As I’ve stated in other posts, if you have to alter a garment more than two or three sizes, you may not have perfect results, but this is excellent for pants that hang a little low.

Leave me a comment or a question at the bottom of this page if you need more clarification. I’ll get an email immediately when you comment and I can answer you quickly.